Antenna Module Glonass DS1513-G

General Description

  Delin Comm DL-1513N-GGCS is a complete GPS&GLONASS engine module that features super sensitivity, ultra low power and small form factor. The GPS&GLONASS signal is applied to the antenna input of module, and a complete serial data message with position, velocity and time information is presented at the serial interface

with NMEA protocol or custom protocol.

Its –165dBm tracking sensitivity extends positioning coverage into place like urban canyons and dense foliage environment where 

the GPS&GLONASS was not possible before.The small form factor and low power consumption make the module easy to integrate

into portable device like PNDs, mobile phones,cameras and vehicle navigation systems.

Features

• Build on high performance, low-power SONY CXD5603GF chip set

•  Ultra high Track sensitivity: -165dBm

•  Extremely fast TTFF at low signal level

•  Built in high gain LNA

•  Low power consumption: Max 8mA@3.3V

•  NMEA-0183 compliant protocol or custom protocol

•  Operating voltage: 2.8V to 5.5V

•  Operating temperature range:-40 to 85℃

•  Patch Antenna Size: 12x12x4mm

•  Module Size: 15.25x13.1x6.55mm

•  Communication type: UART/TTL

•  RoHS compliant (Lead-free)

1.2 Power Supply

Regulated power for the DL-1513N-GGCS is required. The VCC Pin Need a stable DC voltage supply. Power supply ripple must be less than 30mV. The input voltage Vcc should be 2.8V~5.5V, Recommended power supply voltage is 3.3V . maximum current is 8 mA. Suitable decoupling must be provided by external decoupling circuitry.

1.3 UART Ports

The module supports two full duplex serial channels UART. All serial connections are at 3V CMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable,the data format is however fixed: X, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no other data formats are supported, LSB is sent first. The modules default baud rate is set up 115200bps, however, the user can change the default baud rate to any value from 4800 bps to 115kbps. UART port can be used for firmware upgrade,NMEA output and SONY proprietary commands input.

2 Application

The module is equipped with a 7-pin pad that connects to your application platform. The DL-1513N-GGCS module It consists of a SONY CXD5603GF single chip GPS&GLONASS IC which includes the RF part and Baseband part, a patch antenna, a LNA, a SAWfilter, a TCXO, a crystal oscillator